11.0 Optional Accessories
(page 1 of 3)

11.1
The following optional accessories are to be provided with the walk-in and shall be factory installed.

11.2
Exterior Door Ramp:
Shall be sized the width of the door x [30"] [36"] [60"] long.

11.3
18 ga. Stainless Steel Door Kick Plate Set:
Shall be 36" high x width of door and of 18 ga. type 304 stainless steel with corners beveled and deburred. Plates applied to both sides of door.

11.4
Door Closer (Hydraulic Arm Type):
Shall be mounted to top center of door and jamb to provide positive closing of door.

11.5
Burglar Alarm System:
Shall be Class II rated circuit magnetic type completely installed. System shall have contactor mounted in refrigeration system panel to accommodate electrical supply from the building's alarm system.

11.6
Strip Door Curtain:
Shall be NSF approved and labeled and not less than 1/8" thick clear vinyl material. Individual panels of strip curtain shall overlap jamb and each other by not less than 1" and shall touch floor of walk-in.

11.7
Framed Wall Opening:
Shall be of the dimensions shown and located as shown on the plans and drawings and shall be finished with same material and in same manner as the doorjamb.

11.8
Merchandising Doors:
Shall be of the size and number shown on the plans and drawings. They shall be factory mounted and complete with magnetic gaskets, polished extruded aluminum frames, pull type door handles, self closing hinges, tempered safety glass with heated glass on +32° F and below application, door and frame heaters and fluorescent light. Five-tier shelving shall be included as shown on plans and drawings.

11.9
Temperature Alarm:
Shall be provided to activate when compartment temperature rises above the set point. Power shall be 120V/60HZ/1PH.

Next Page
Back to Specs